Okay, I'm trying to compile a parts list, please check me:
-Trans: TKO 600 (what cars used them, stock?)
-Throwout: Late Dodge/Jeep
-Pilot bearing: Mustang? Dodge? Jeep? It wasn't really clear to me?
-Tranny mount: Gm standard (can you provide a part # for the mount you used?)
-Slip yolk: Ford AOD, C6, others
-Crossmember: Custom, must cut out stock hoop
-Bell housing: Scatter shield (I assume that you could modify a stock one if needed?)
-Pressure plate: ???
-Clutch disc: ???
-Clutch arm: Stock Mopar
-Clutch linkage: Stock Mopar?
Your pictures were very informative, I am just unclear about a few things from your first post.
Thanks!
Nick
Also, did you have to shorten the driveshaft for the application? What U-joint # did you use to go from Ford yolk to Mopar driveline? How did you adapt the speedometer cable to this trans?
Thanks again!