|
Re: help me build a engine!
[Re: 451Mopar]
#1371029
01/18/13 06:35 PM
01/18/13 06:35 PM
|
Joined: Nov 2008
Posts: 1,491 Lethbridge, AB, Canada
dangina
OP
pro stock
|
OP
pro stock
Joined: Nov 2008
Posts: 1,491
Lethbridge, AB, Canada
|
Quote:
The stroker kits are pretty much all the same cost, and stronger than stock cranks and rods.
For what your doing, the 511 (4.25" stroke) stroker kit with 24cc dished pistons and Edelbrock RPM (84cc) heads, with zero deck and 0.040" head gasket results in 9.88:1 compression. The dish on the pistons still leaves a good quench area, and the compression is good for pump gas with the cams you will be looking at (likely in the 240 @ 0.050" range.) Maybe Comp XE285HL? for good low/midrange power, good for a daily driver, but should have a noticable idle, but not choppy like a race cam.
Thanks guys, so is it the dish of the piston that determines quench and compression? Which kits do you guys recommend? Been looking at the muscle motors kits, haven't heard anything bad about them, the 440source kits have mixed opinions
|
|
|
|
|
|