|
Re: Carb Tuneing
[Re: Moparnut426]
#1092739
10/11/11 06:38 PM
10/11/11 06:38 PM
|
Joined: Feb 2005
Posts: 5,221 Branson, Mo.
joedust451
super gas
|
super gas
Joined: Feb 2005
Posts: 5,221
Branson, Mo.
|
Quote:
So how do I adjust it out of that if its past the idle cuircut
Kasey
Square up the transfer slots on the primaries, even if its 4 corner idle the rear ones sit higher on the base, so you may never exspose them unless you open the butterflies more then the primaries, so start off with squareing up the front slots, then find out how far you needed to turn on the throttle screw to reach it, then open up the secondaries as much as the front, so if your primary throttle screw is 1.1/2 turns from fully seated, then set the back at 1.1/2 turns, then set all mix screws at 1.1/4 open, fire it up, make sure float level is good, set timing for highest manifold vacuum, then tailer in the mix screws & throttle shafts to obtain the best idle & the RPM where you want it. Hope this makes sence.
|
|
|
|
|
|