Quote:

I have been through this personally with a couple of Eddy 750's and I have a solution that Does Work!

1) Verify that your floats are set properly

2) Verify that your accelerator/plunger is good(replace if any doubt)

3) Adjust the linkage that operates the accelerator; There's 3 settings, I believe the arm should be in the top hole.

4) Finally, the thing that most guys won't try: Remove the Primary Squirters and drill them out very, very slightly(get some tiny, tiny drill bits).

The last one is what did it for me.

Let us know how you make out.




so you're suggesting drilling out the accelerator pump shooters slightly?
I can do that fairly easily! the kit they sell has three sizes and maxes out at .043" compared to the .035 on there now