Well ran a leakdown test and cylinder #3 would not hold pressure at all. Not sure if it was the head gasket or piston rings?
Cylinder may have not been firing? not sure yet. Going to put a new head gasket on tomorrow and re-check leak-down.
All the other cylinders were good, showing about 39 psi when set for 40. Much more than 40 psi and the engine would rotate over.
All the valve gear looks fine, so I'm thinking oiling is good. I forgot to take a photo of the valve stems that show a nice centered contact pattern from the rocker arms.

Oops forgot on the Radiator pressure test, could not build pressure, but had a loose heater hose connection.
Need to retest the cooling system after replacing the head gasket.