I've been fighting with the PPP bracket that connects the cable to the transmission. I ordered the one for use with a blanket and it flat out won't fit. It hits the floor and required so much trimming that it compromised the structure. Even after my hack job the bolt holes won't align up due to the cast transmission pan. Absolute junk in my opinion. I wrestled with the idea if Sh%&-canning the entire shifter set up, but JBODY replied to my "help" post with a really cool idea for a bracket (apparently I'm not the only one with this problem). Here's my "junk" solution; I hope it helps others. I went off the top of the rear "ear" of the transmission (JBODY went under). I don't think it matters as long as the cable doesn't bind. "All-in-all" I hit all gears and PARK smoothly with no binding. If you order PPP, buy the cheapest bracket possible as it is just used as a template for your fab work (still kind of pi$$ed about that one).

My PPP "help" thread.

PPP Bracket:

Untitled by Greg Ault, on Flickr

Untitled by Greg Ault, on Flickr

Untitled by Greg Ault, on Flickr

Untitled by Greg Ault, on Flickr

Untitled by Greg Ault, on Flickr

Untitled by Greg Ault, on Flickr


JBODY's solution:

IMG_2974 by Greg Ault, on Flickr

IMG_2975 by Greg Ault, on Flickr

IMG_2976 by Greg Ault, on Flickr