Update, it runs, no bad noises, cold oil pressure is 70-90 psi depending on RPM, hot(170F) oil pressure at idle (1150)is 40-45psi. oil pressure goes to 90+ when you bump the throttle. I did run it at 2500 to 3000 for 2 to 3 minutes to make sure the oil was gettingg back to the oil pan. So far the oil is nice and clean no water in the oil. The only thing I am concerned about is the amount of oil going to the top end, not much getting there. There is a leak on the front of the lifter valley cover I think that it's the set screws for the oil passages to the opposite side lifter galley, crank case vacuum is good. I took a video but it sucks so I am not going to post it. I plan on running it and working out some small problems and then go to the dyno.
Mike