One new snag I just discovered is that my speedo does not work because I deleated my ABS controller. The donar Ram 1500 only had rear wheel ABS and the control box was pretty small, so I removed it along with some of the wiring. It seems that I will need this unit to convert my rear axle VSS before it goes to the PCM. Since it already has been 4 years since I started this project, I no longer have this controller. I found a few used ones on Ebay for about $150, but I don't want to use one if I can just convert the signal without it. Also since I won't actually be conecting any brake lines to the unit or a brake fluid level sensor, this ABS controller will be sending out all kinds of trouble codes. I really doubt any other Hemi/45rfe swappers are using the ABs either, so someone out there has come up with a fix. I sure would like to keep the dash I am running and it would be even better if it actually all worked.