Quote:


I wonder if it will be possible for me to pull the engine out the top with the K-frame in? This was done in response to the previous pan bottoming on a huge pothole and ripping the drain plug half out. Four quarts on the ground in about a minute. I suspended the engine, removed the K, swapped in the pan and started measuring and trimming. Then burned in a few pieces of reinforcement with the stick welder.




Mike.

I put my smallblock in from the top. No headers and no trans. Would not be able to do it with trans still on it.



TIGHT FIT


7020970-3_19_11Sm62.JPG (118 downloads)
Last edited by autoxcuda; 01/16/12 12:11 AM.