Quote:

---

Not going to run it, I was just going to swap parts and see if the valves open....

Non adjustable rockers are on this motor. When I put it together years ago, it was a pump gas motor, in a truck that I drove on the street, 4 wheeled and street class truck pulled. It was an idle to 5500 engine. I put the small chamber heads on, switched to E85, and put a used twin disc clutch, and took the truck off the street. When its right it turns about 6000 rpm down the track with good power. I'm hoping to finish up a couple hooks yet this year, and next year building a fresh 470/iron head engine(rules on heads and cu.inch) and get some nice performance parts.

I'm not planning on doing anything to wipe the cam out, just making sure I spend money on the right parts. Been chasing this problem for a while. Don't want to spend more money then I have to on this bullet.

Michael

---