Thread/project from the dead......

I have been busy these last few months with a new job, the birth of my son, and a move. (I HATE moving btw) Anyway, I have had very little time to work on the charger but I'm trying to sneak out to the garage (now a little two car garage) when I can.....

I just made this piece and I'm a bit proud (hints the post) of the way it turned out. I needed some way to connect my budget turbos to the down pipe as these turbos use a sealing ring instead of a V-band. The OE piece is cast so I made this guy that I can weld to instead...

The factory adapter pipe is siting on top..



Seal ring groove cut, inside step turned to accept the pipe and tapering the end to make welding easier.



Finished piece, one down, one to go.