700 with OOTB -1's and a low lift Solid Flat tappet to me seems pretty impressive!

Originally, I was going to go with -1's when the Chapman MW deal kinda fell into my lap.

Your motor and cam is very similar to my 517 (I run a Bullet HR with 264/268 @.050) but what is your ICL?

Your torque is nice and flat....over 600 throughout nearly your entire pull.

I might have revved it 500 past peak, just to see how quickly it fell off and maybe richened the jettting a tad to be safe. But then again, where you peaked is about where I would have expected and from graphing the torque drop off you can pretty much predict it. A bit more intake lift with a -1 might squeaked out a bit more torque but it still a nice power curve.

Congrats, IMO 700 without a lot of RPM and basically pump gas compression is the way to go for a long-lasting bracket motor. no sense chasing the last bit of HP if it takes raising the torque peak higher and stressing the block further.