Here's Dave crunching various RPM/Vacuum #'s during warm up trying to figure out what RPM/Vac reading would give us the best score. He calculated 910 RPM/6.0 was where we would score best so I went in and tryed to set the idle as clse to his goal as possible. In the end after 5 minutes of idle and then 1 minute of recorded idle, we had 930 RPM average and -5.9 vacuum, so I set it about as close as I could to his target.

if you look real close you can see alot of data on the screen including the corrected DA on the lower right corner, it reads, DA, VP, baro, humidity, and inlet temp in that order starting from bottom up. Harold welded in a O2 bung in our headers on Tuesday night so we could run the LM1.