Quote:

Quote:

Quote:

I remember reading sometime back about someone doing a 500cfm center carb conversion on there 6BBL. I think it was a Ford 2BBL carb from a circle track engine using Chrysler 2300 shaft and linkage. The airhorn/choke tower was milled down and so was the carbs base where the air cleaner sits so the 6bbl base could be used.

I've been looking for it for sometime and I can't find it I guess my search kungfu is weak..



I did it




Yours looks like all 3 carbs are done, the write up I read was just the center carb (500) with the vac outboards, I cant remember if they used the Ed intake or Weiand's IR tunnel ram...

There is a cool youtube vid, they seem too have the carbs dialed pretty smooth, posted by 4406Chally.

www.youtube.com/watch?v=zJW5bwmuSmo



PPM builds the engines for the old Paul Rossi super stock six pack challenger. That is their own intake after spending 10,000 dollars on intakes made by hogans and others that wouldnt get down the track. The 4412 ( i think) holley 500 has a boss in the same spot where the vaccum port needs to be for the outboards. Yes, my set up ended up being 3 mechanical carbs.

Gen 3 power 6.22@110, 9.85@135
Follow @g3hemiswap on instagram

performance only racing, CRT, ultimate converter, superior design concepts, ThumperCarbs