dammmm !!! another variable thrown into this .......


so now i need to pull the shaft and start over .... ?


Mr. P - how much taper are we talking about ?? would you say 1 degree? 2 degrees ?



we need a smiley figure that puts a gun in his mouth and blows his head off........

---

I dont really know... I never measured it but you
can see it.... just trying to warn you... you can
measure off the U-joint cap if you want... I made
up a quick little tool for measuring off the cap but
you can use a socket that fits and put your inclineometer
on the socket... you will notice that one side is
the pinion and the other is the drive shaft, just
take the reading at the bottom(closest to the ground)