Quote:

I did some calculations....I looked up the stock deck height (this engine was never apart either) I got 9.98 IIRC. I took the rod length + the SpeedPro's CH of 1.920 + HALF of the 3.375 stroke, subtracted from the favtory deck height spec and....from my calculations.. am ASSuming the 2315 pistons to be .0145 in the hole.




Your math is right, but 10 bucks says your deck height is not 9.980" from the factory. Not that it really matters, just that you'll have to mill a bit more than 0.010 off your block to get it where you want.

Dropped off my 383 block and crank at the machine shop yesterday

Good luck