Quote:

if i need more clearance how and i going to get it?




Hello,

I was in the same position a while back with an assembled motor in the car. I removed the heads and sealed off one hole at a time. Greased the cylinder walls, piston top and especially the clearance around the edge of the piston. Load it up real good. Then went to town with a grinder to the eyebrows. When done wipe the grease off in layers until you get down to the metals. Do a super cleaning and move to the next hole bringing that piston up and sealing off everything. Was not too bad. In a few hours I had the clearance needed and hardly spent any of my college beer money.

Damon