I finally got my arms painted. I started on lowering the front last Sat. but smashing my fingers (bled through my left ring finger nail) while loosening the pivot bolt and trouble locating a 3/4" drill bit has held me up. I fooled with it a little today after work. The holes in my driver's side control arm didn't line up with the ones on the pivot bracket. I found that the metal around the pivot bushing was up against the pivot bracket. I had to grind off a little metal around the top on both sides to leave some room for the arm to move.

I had to drive around to find a 3/4" drill bit. I finally ended up buying one of those unibits. I had to drill the front and back for both holes to get it right because the steps aren't wide enough on the unibit.