|
Re: 340 wouldn't seat to 833
[Re: jahsh]
#543020
12/02/09 11:17 PM
12/02/09 11:17 PM
|
Joined: Jan 2003
Posts: 75,274 A gulag near you.
JohnRR
I Win
|
I Win
Joined: Jan 2003
Posts: 75,274
A gulag near you.
|
Quote:
Quote:
Also you may want to check to make sure old pilot bushing isn't still on the output shaft of the tranny. Did you replace the pilot bushing ? Do you remember seeing the old one ? I have seen that a couple times. And it won't look real obvious. Tap it with a punch, if it marks, I'd say the bushing is still on the shaft. Good luck.
Good thought, but unfortunately not the case - my guess is that the hyd TOB wouldn't even slide onto the output shaft if the bearing got dislodged from the engine and stuck onto the shaft.
A slightly off alignment could still be the issue, but that plastic alignment tool sure fits in there perfectly.
just realized you have a HYD. throwout bearing , you are screwed , can't slightly disengage the clutch wit ha prybar ...
And again , just beacuse that little plastic tool fits in there does not mean it's perfectly aligned , especially if the bellhousing is a little off center .
|
|
|
|
|
|