Quote: I tell you this. it is way to hard to tell.one thing it is feel thing about how much pressure you use to get that ..pattern. I use a 3ft bar to loan /put pressure to get the pattern.. you can not loan it like it would be in the car. so how do you ask someone how much pressure did you use to get that pattern?..I going to asume he doing this by hand with light pressure. he is not far off. I see them be dead on and the rear end make noise. I see where you think they would make noise and don't..I do this for a living I build at lease one a week..
Jamie,the drive side isn't to bad,but the coast side pattern is not consistent from tooth to tooth and the angle or pitch seems off.I wander if the ring gear is seated on the carrier flange flush or the races seat squarely in all the bores.We like to see a consistent contact patch either in the middle of the tooth or to the lower 2/3 and similar on the drive and coast.Maybe Doctor Diff will chime in.
