at that light of weight it could likely even be done with an eddie head...but a w2 motor would surely do it,any other head would more than get it done(W5/INDY...ETC)
If i were to do it the cheapest way,this is what i would do
904 trans
5100-5200 flash 8 inch convertor
ryan ported eddie heads
13-1 compression
a roller along the lines of about 266/272 at 50 about 650 lift
good hp 950 carb
1/78 headers
should go 10 flat relatively easy...
Last edited by B3422W5; 10/30/06 04:50 PM.
69 Dart GTS A4 Silver All steel, flat factory hood, 3360race weight
418 BPE factory replacement headed stroker, 565 lift solid cam
Best so far, low 10.30’s 1/4
1.41 best 60 foot
6.56 at 104.17
| 
