Thanks everyone, I am new to posting and trying to figure out how to answer, I started with stock pins and found it was out -.026 and have installed Robb mc pins .014 offset and the pic of the reading is where it currently sits I think I am reading the dial correctly at 3 o clock its on the 7th mark before zero on my my dial whiich I would think is negative then at 9 o clock its the 7th mark past zero which I think is positive, this is the first time I have done anything like this and I am not sure if the pins need to both point in the same direction, the book says .008 max runout I know I am unclear what this number is, the help here is greatly appreciated bare with me on trying to figure how to respond to everyone