Drill for clearance, or replace?

Print Thread

Re: Drill for clearance, or replace? [Re: 451Mopar] #2704103 10/05/19 12:59 PM 10/05/19 12:59 PM
Joined: Nov 2003 Posts: 36,041 Lincoln Nebraska R RapidRobert Circle Track
RapidRobert Circle Track R Joined: Nov 2003 Posts: 36,041 Lincoln Nebraska	if you have an 1/8" dia passage left after the misalignment you are fine (& 1/16 is fine on the 1,3,5 non oilers). EDIT if you can stick a 1/16 drill bit in the holes you are set, no opinion on the bearings too far lateral (I'd mockup the cam) but I got a feeling you are OK. MORE EDIT meant to say 1/8" (#2 & #4) Last edited by RapidRobert; 10/05/19 04:07 PM. live every 24 hour block of time like it's your last day on earth

Entire Thread
Subject	Posted By	Posted
Drill for clearance, or replace?	Diplomat360	10/04/19 10:13 PM
Re: Drill for clearance, or replace?	Sniper	10/04/19 10:26 PM
Re: Drill for clearance, or replace?	Cab_Burge	10/04/19 10:34 PM
Re: Drill for clearance, or replace?	lewtot184	10/04/19 10:42 PM
Re: Drill for clearance, or replace?	Sniper	10/04/19 11:02 PM
Re: Drill for clearance, or replace?	70sixpkrt	10/04/19 11:04 PM
Re: Drill for clearance, or replace?	MoparMike1974	10/05/19 04:00 AM
Re: Drill for clearance, or replace?	fastmark	10/05/19 10:32 AM
Re: Drill for clearance, or replace?	440_Offroader	10/05/19 03:43 PM
Re: Drill for clearance, or replace?	Sniper	10/05/19 03:56 PM
Re: Drill for clearance, or replace?	451Mopar	10/05/19 04:12 PM
Re: Drill for clearance, or replace?	RapidRobert	10/05/19 04:59 PM
Re: Drill for clearance, or replace?	pittsburghracer	10/05/19 11:41 PM
Re: Drill for clearance, or replace?	Diplomat360	10/06/19 01:34 PM
Re: Drill for clearance, or replace?	IMGTX	10/06/19 02:08 PM
Re: Drill for clearance, or replace?	Magnum	10/11/19 02:41 AM
Re: Drill for clearance, or replace?	IMGTX	10/12/19 03:16 PM

Hop To