Only one I was concerned about was the drivers side on my 383/432 Stroker
Did it at work with a drill press
Two summers now
Cheap Anchor motor mounts from OReillys
Zero Zero Zero Vibration
Thanks for the pics. This might be the way to go.
I see you assembled them, then drilled thru the mount and the bracket.
Probably the easiest and cheapest.
Yes
If you decide to buy from your local jobbers
Take them out of the box first before walking out
Look at where the nut is welded to the mount etc
I must have had ten in my hand before picking two that I was happy with from different jobbers
Then Ace Hardware for that countersunk grade 8 bolt etc.
So far so good