Quote:

Ok.. i am using stock axels in the spool .. and i want the stock tappered roller bearings for stronger laterial strength.. Not the ball bearing green bearings.. the is not a street car or a drag car... its another form of racing that some people on here might find offensive.. Needless to say i need the strongest laterial setup possible for my axels, I do not want to risk breaking an expensive aftermarket axel when there are so many c body axels around.... So what could a guy do for a spacer to adjust the end play on stock axels and bearings on a spool..

Another question ..

When you guys twist the splines on your stock axels in a spool does it wreck the spool? and how do you guys get the axel out in a hurry ?

thanks everyone




You wont twist the axle in the spool, it will be right
after it exits the spline on the spool. Word to the
wise.... paint a stripe down the length of the axle,
this will tell you the wind up in the length, about
a 1/4" wide