I'm getting close to stuffing this thing in from underneath and have never done this before. Put lower control arms and strut rods on and began to wonder how much of the front suspension can I install? I believe I have to leave the pivot shaft nuts and strut rod nuts (ones at the front) finger tight untill I can lower the car to "seat" the pivot shaft then tighten. Can I install lower ball joint, steering knuckles, front backing plates w/wheel cylinders, Idler arm, pitman arm and center link as well? My fear is that if I do that and install I won't be able to get upper ball joint into the top of the knuckle. Any advice would be much appreciated as I don't want to do this twice.