Quote:
You did an outstanding job fitting that trunk hinge panel.......however, that panel is pretty darn flexible, so it sure would have been easier to cut it off square, pull it over a tick and just weld it across the top...........LOL!!!!..........May have cut that 73 times to 2 or 3..........LOL!!!
Monte
Would have been easier but inner tub moved over 3 1/3 inches into this panel. The trunk lid tortion bars would have had to been shortened if I moved the panel over with the tub. There were a few cold ones and a lot of staring at it before grinder went in hand LOL. I wanted it to look like it was made like that.
05 Ram 1500 Daytona package
71 Demon Gen3 hemi drag radial project
Missin' my 9 second 70 runner!
| 
