I have a couple questions before I reassemble my rear end. I got the housing painted and my carrier is completely built. I just have to do the final assembly. I got all of my parts from Dr Diff. Everything was replaced with Timken bearings and I should have all of the proper gaskets on hand. After the carrier is set on with the gasket, what's the best way to install the axles and setting the proper axle play? I've read my service manual and it talks about utilizing the backing plates and a dial indicator to set it, but I don't plan on going to drum brakes and I don't have a dial indicator on me. I've got tapered axles on my setup. Also, there seems to be a spacer that's supposed to go in between the axles in the carrier. How am I supposed to set it in there without dropping it in the housing before I install my axles? Thanks for all of your help guys! You've been great help so far.