Have a 69 charger, crate 528 hemi, Schemacher engine mounts and TTI 2 1/8 headers.5spd TKO Keisler tranny
When I had this engine installed with a 383 sat level in car.
Fan spacing was even top to bottom being parallel to core.
Now with Hemi sits low at firewall. Spacing at rad maybe 3.5 " at top 1" at bottom.Headers seem to hang down quit a bit as well.
Anyone else have this combo ?
Tried spacing tranny further up but hits floor.Short of cutting out more dont know what else to do.
Looks like there is room for it to go up looking at headers and where the bends are for suspension etc.Doesn't seem to bother engine not being level
other than I want to install a rad shroud to stop overheat in stop and go traffic.

Any comments would be greaty appreciated


69 dodge charger,528 Hemi,Keisler TKO 5spd, Mosier 60 rear end