Quote:

Thanks, that is the same way I do my solid cam. For me the hard part is feeling that "0" lash to know when to do the 3/4 of a turn.




"Think" about what you are trying to accomplish

If you loosen it until you have a bit of play up and down the pushrod will roll very freely as there is no pressure on the tips.

Then slowly begin tightening while rolling the pushrod between your thumb and forefinger,

when your reach zero lash, there will be a very distinct difference in the resistance as you have removed the clearance and are beginning to add pressure to the tips. IE: ZERO LASH

If you want, loosen it slightly to verify that the resistance goes away, retighten and you should find the adjustment is exactly the same.
Try it, Repeat it several times and I believe you may go WOW!!! that was simple.
Then add your preload, tighten the locknut and go onto the next

Last edited by TJP; 11/23/13 05:55 PM.