Ok, I was looking at the Mopar Performance Chassis manual page 119 figure 6-13. I've looked at it about 5-6 times since last night and I think I finally figured it out.

Note: It would have been a lot easier if MP would have just put a line between the main and cluster teeth counts to signify divided by. You no, since that is how they do it in mathematics.

MP must have been trying to save ink.

1st gear ratio=

(35/17) x (30/25) = 2.47

2nd gear ratio=

(34/23) x (30/25) = 1.77

3rdd gear ratio=

(29/26) x (30/25) = 1.39

.
.
.
.
Am I correct on this?

Do I get a happy face sticker?!

Last edited by autoxcuda; 10/27/12 12:19 AM.