your running right at the same spring pressure that i run with the same head. my lift is at .693 and run 1.950 installed. i dont like the length of the rocker studs supplied from eddie and t&d as they dont allow the studs to use the full thread engaugement that the head prvides. anainst my will, i bought the studs from indy, as they are longer and go further in the hole. i remember you having this issue before, and thats what prompted me to get the longer studs prior to running my engine. also did you set the shimming yourself? i've seen and read on this post that some machine shops had set the coil bind figures wrong. good luck.