I was figuring in the .o12" off the block that gave me .072 total off the deck and heads.Multiply that by .012 = .o86" needs to come off the intake .
But is that going to work with just a vally pan gasket?
I did this on a 383 and used the felpro intake gaskets on both sides and the vally pan gasket . we wacked the intake .090 " not sure if i should of .Still don't think it is right because the intake might of went on with just the tin pan. At the time i was new to mopar engines and thought i had to use the paper gaskets because they came with the intake set .
Is there way to get an impression of where the intake sitts with grease and paper or cardboard ?