Quote:

I have bench adjusted the shifter stops too tight more than once. Just unscrew the stop all the way out and try some shifts to see if the grind is gone.Readjust stop inward as necc.Clutch plate departure is also very important-but you stated the other gears shift fine.Are you shifting all gears at same rpm? Check for deflection in linkage as previously suggested. Good luck. Chris




Hey Chris, it doesnt even matter what rpm it is, under any kind of partial or full throttle it grinds going in...all the other gears are fine when im on them hard or just cruising into them

I double checked the stops today and sure enough there is actually quite the gap on the 2nd gear stop....so now im thinking maybe its the fluid?