Re: Once again "DON'T ASK ME HOW I KNOW"
[Re: 23T Hemmee]
#616885
02/18/10 05:45 PM
02/18/10 05:45 PM
|
Joined: Jun 2004
Posts: 767 NW PA
V10nacuda
super stock
|
super stock
Joined: Jun 2004
Posts: 767
NW PA
|
After using the trailer jack to tilt the trailer front up enought to load a low car. DOn't forget to retract it COMPLETLY & then wonder why a friend going by you is pointing like a madman at the rear of the empty trailer. Cause next time you use the trailer it wont go as high because the jack is a few inches shorter.
Last edited by V10nacuda; 02/18/10 05:46 PM.
|
|
|
Post deleted by Defbob
[Re: dc426]
#616888
02/18/10 06:11 PM
02/18/10 06:11 PM
|
Anonymous
OP
Unregistered
|
Anonymous
OP
Unregistered
|
|
|
|
Post deleted by Defbob
[Re: galen]
#616890
02/18/10 06:12 PM
02/18/10 06:12 PM
|
Anonymous
OP
Unregistered
|
Anonymous
OP
Unregistered
|
|
|
|
Re: Once again "DON'T ASK ME HOW I KNOW"
[Re: slantzilla]
#616893
02/18/10 07:06 PM
02/18/10 07:06 PM
|
Joined: Jun 2004
Posts: 140 Fort Worth, TX
DMax One
member
|
member
Joined: Jun 2004
Posts: 140
Fort Worth, TX
|
When you have a nitrous explosion in the intake on the launch, don't continue to drive on down the track scattering little pieces of a plastic airhat all the way down the track. "because it was still running" Secondly, don't do it twice in the same weekend. DAMHIK
68 Barracuda FB "Exploded View" ...still :-(
2008 Ram 2500 CTD
2007 H.D. Softail Custom
92 Jeep Cherokee
|
|
|
Re: Once again "DON'T ASK ME HOW I KNOW"
[Re: '72CudaRacer]
#616897
02/18/10 08:08 PM
02/18/10 08:08 PM
|
Joined: Mar 2003
Posts: 2,524 PA
moparacer
master
|
master
Joined: Mar 2003
Posts: 2,524
PA
|
If your a box racer dont forget to change your opponents dial in before the next round....
Dont ask me how I know.....2 or 3 times at least....
67 Barracuda street/bracket car 11.27-119 68 Dart 502 BB 8.70s-152 414 cid SB Dragster 7.65-174
|
|
|
Re: Once again "DON'T ASK ME HOW I KNOW"
[Re: '72CudaRacer]
#616898
02/18/10 08:10 PM
02/18/10 08:10 PM
|
Joined: Nov 2009
Posts: 3,410 Belpre,Ohio
CHAPPER
master
|
master
Joined: Nov 2009
Posts: 3,410
Belpre,Ohio
|
#1. If you grab a "spare" carb off the shelf to install on an engine,,make sure you didn't take the floats out of it for a buddy to use till his new ones come in the mail. #2 If you have an engine 'full of fuel' and you remove the spark plugs to crank the engine over to keep from hydraulicing and bending a rod, make sure you have the spark plug wires away from the plug holes or the ignition off. #3 Always have a fire extenguisher handy for any unexpected fires.
If you like drag racing, support your local track.
|
|
|
Re: Once again "DON'T ASK ME HOW I KNOW"
#616899
02/18/10 08:15 PM
02/18/10 08:15 PM
|
Joined: Jan 2003
Posts: 3,789 Detroit Michigan
drbill
master
|
master
Joined: Jan 2003
Posts: 3,789
Detroit Michigan
|
Where do you want me to start, cuts, burns or general stupid stuff Never grab a brake drum by the center hole after you just used a torch to heat it up to be able to remove it from the axle. Never use chlorinated brake clean to clean the throttle body on a running Mercedes Benz. Never grab the fan shroud to stop your car from rolling into the fence because you forgot to set the parking brake while adjusting the idle mixture screws on the carb.
|
|
|
Re: Once again "DON'T ASK ME HOW I KNOW"
[Re: galen]
#616902
02/18/10 08:33 PM
02/18/10 08:33 PM
|
Joined: Jan 2003
Posts: 549 Bristol, Va
fasteddie
mopar
|
mopar
Joined: Jan 2003
Posts: 549
Bristol, Va
|
ALWAYS, and I mean ALWAYS, put the oil filter on before priming the oil pump of a new motor.
Funny thing is I've forgotten to do this twice, about 20 years apart.
2003 Bristol Dragway Sportsman Champion
2016 Bristol Dragway Power Hour Champion
|
|
|
|
|