|
Re: New engine dyno numbers???? E street
[Re: demon440]
#1429712
05/05/13 09:18 PM
05/05/13 09:18 PM
|
Joined: Jun 2010
Posts: 57 CT
440Kilmartin
OP
member
|
OP
member
Joined: Jun 2010
Posts: 57
CT
|
|
|
|
Re: New engine dyno numbers???? E street
[Re: demon440]
#1429713
05/06/13 12:07 AM
05/06/13 12:07 AM
|
Joined: Nov 2009
Posts: 3,082 St. Paul , Mn.
tubtar
master
|
master
Joined: Nov 2009
Posts: 3,082
St. Paul , Mn.
|
Quote:
Isn't the combustion chamber in the head the same as the bowl?
Bowl is up stream from the valve .....towards the carb on intake , exh on exh. The typical choke point in a lot of heads and where big gains can come from when porting. Chamber = pocket on combustion face of cylinder head deck area where valves & spark plugs hide.
|
|
|
Re: New engine dyno numbers???? E street
[Re: 440Kilmartin]
#1429716
05/06/13 12:18 PM
05/06/13 12:18 PM
|
Joined: Jun 2006
Posts: 5,163 CT
GTX MATT
master
|
master
Joined: Jun 2006
Posts: 5,163
CT
|
Mike I probably didn't have a car with me since mine has been out of commission for about 2 years now (for about another month or so only, hopefully!) but I've got a gold '67 Satellite with a 440/4 speed.
Good luck with the 23 spline. I'm going to be pushing one soon too with my stock stroke 440, looking to be around 550 hp so I'll be a bit safer than you with the stock stroke and less torque, but still looking to put the hurt on it (and the 8 3/4 behind it). I've got 3 so I'm prepared to break one, trying to trade up for an 18 spline though.
You did have a 4.10 Dana though as I recall. You running a scatter sheild?
Now I need to pin those needles, got to feel that heat Hear my motor screamin while I'm tearin up the street
|
|
|
|
|
|