|
Re: Let's see your homemade floor jack transmission cradles
[Re: JohnRR]
#1110886
11/10/11 09:28 PM
11/10/11 09:28 PM
|
Joined: Aug 2003
Posts: 4,981 new jersey usa
11secdart
master
|
master
Joined: Aug 2003
Posts: 4,981
new jersey usa
|
I bought one a long time ago that works the same way, its basicaly a flat piece of steel with 3 sides a couple inches high and a post on the bottom to go into the floor jack hole. Its definetly a life/time saver, I think it might be made by TCI.
68 Dart 410 / 904 92 D150 original owner 21 Ram 1500 Quad Cab, Big Horn , Hemi ,4x4 23 Audi Q5 16 Honda HRV
|
|
|
Re: Let's see your homemade floor jack transmission cradles
[Re: Shoozy]
#1110888
11/10/11 11:12 PM
11/10/11 11:12 PM
|
Joined: Jan 2003
Posts: 738 Columbus Ohio
mopfried
super stock
|
super stock
Joined: Jan 2003
Posts: 738
Columbus Ohio
|
I dont have a picture of it but, I used a flat piece of steel with a pin welded to it on the bottom. On the top I welded a 3 foor section if 3/16x 2-1/2 angle iron about 36 inches long. lay a thick rag on it and set a door on it and one man can install a door. Made one for my son to use in the body shop..
duh, I re-read the post and saw it says TRANSMISSION... oh well
Last edited by mopfried; 11/10/11 11:13 PM.
|
|
|
|
|
|