for your set up your going to have to to mount your ties rods on the bottom side of the steering knuckles you'll have to get a reamer or have a shop do it.your going have to lower your strut arms below your arms by a block or someother means on the top. I haven't done it yet but I was going to cut a piece of tubing in half and cut out a relief in the control arm and weld the 1/2 piece tubing. you folowing me. my trucks not quite as low as you used 3" drop springs (not sure if thats been done before) any way in my truck (I have no bump stops) I have hit the steering shaft the other day I was hauling butt trough a dip. so I was going to do the control arm mod and reattach a cut down bump stop, also I still have yet to buy my new dropped shocks so this might help also