Quote:

Quote:

Do anyone of you have pictures of your Ladder bar/coil over set-up on your A-bodies w/ stock frame rails? Did you have to cut the floor? I'm getting ready to do the install on my 66 dart and its easier to get ideas from pictures of others who have done it.

Any pointers for a first timer?



How many holes in the front mount, most of the time you
cant get the bar angle low enough. Try to set up the
front so at least the bottom hole will give you a
downward angle of a few degrees. You will need good
adjustable shocks for the rear to control the body
seperation




I haven't bought the stuff yet. I've been looking at the CE crossmember. I see their front crossmember has 3 holes while others have 5. Could I get away with 3? When I mount it, do I want to mount it so the middles hole is level with the ground at ride height?

I was planning on using either QA1 single adjustable or Alston Varishock single adjustables for coil overs. The car won't be purely a race car so I don't need the double adjustables. At this point, I'd rather have the car on the ground and driveable.

Thanks for the pics Al. Did the upper coil over crossmember go through the floor, or were you able to keep the trunk floor pan stock?

Anyone have anymore pics??? It is very much appreciated!!