Heads are done and assembled. I didn't like the stock valve job so we did a nice 5 angle job that picked up a few numbers on the flow. Also took a small surface pass to make a better finish to seal the deck. Set-up new springs and cleaned up.

Molnar crank and rods have arrived as well as the bearings. Custom Diamond pistons have arrived yesterday so the rotating assembly will be balanced on Friday (tomorrow).

Block work is just waiting on my new torque plate to arrive. (anyone building a gen 3 in DFW can "rent" my torque plate if they have the work done by Wells Racing Engines).

My timing cover will be done this weekend. Motor plate template is finished.

New custom Innovators West balancer is on order.

6.1 Intake has been extensively modified by me. Custom 3d printed adapter for the Holley Sniper LS throttle body to intake is in process.

Lots happening on this build. Should be putting everything together starting early to mid December.