|
Re: ((((((((((Gbob's Dyno #'s))))))))))))
[Re: 451Mopar]
#237575
03/01/09 01:15 AM
03/01/09 01:15 AM
|
Joined: Jan 2003
Posts: 3,616 Riverside, Ca
G_bob
master
|
master
Joined: Jan 2003
Posts: 3,616
Riverside, Ca
|
Quote:
I installed my springs at 2.00", but it took using increased height retainers (+0.100"), locks (+0.050"), and cutting the spring pockets about 0.040". This was with loosing 0.060" install height to the lower spring locators/cups. The springs I used are PAC 1325 valve springs. These are 1.55" diameter, 150 lbs @ 2.00", 765 lbs @ 1.20", good for 0.800" lift.
The Edelbrock head valve seats are cut to handle larger diameter springs, but I am not sure about rocker arm clearance with 1.625" springs?
Here you can see how close the springs are to the rockers on the shaft.
Brian measured, and my 1.7 T&D's would have cleared 1.625 springs. If I had gone with a bigger cam, we probably would have gone with the 1.625's, but since it is "smallish", we used 1.55's.
|
|
|
|
|
|