Quote:


Yeah, also talking about this on FABO. We didn't realize the brake and bbp axles stuck out so far. I may try doing an 18 x 9" on all 4 corners with the same bs and just running 255/40/18's.



That should fit easily, too bad you are not local, I know where a few wheels are you could test fit. Do a few quick measurements on the rear, I think the 18x9 w/ +35mm to +38mm should work fine for you. I run 3" studs on the rear and bought a 1/2" hub centric billet spacer from the same guys that sell the wheels. I think they also sell 1/4" spacer. I used cheap auto zone spacers and flat washers to figure out what spacer thickness I would need. The wheels I bought are thick in the center, the 2" studs that came with the Dr Diff hubs barely made it through the lug nuts. I bought 3" studs for the front and swapped them out: http://southwestspeed.com/?sec=view_part&id=24534 I already had 3" studs in the rear.

*I do not have a spacer on the front*

-Michael

Last edited by 68cuda440; 09/16/14 01:58 AM.
Michael 1968 Barracuda Notchback Coupe 440 EFI 6-pack, T56 Magnum 6-spd