I stick to my guns on this one. The top one is marginal but the next two pics show where the top coating is trying to smear and guall along with way to much detonation. I bet if you mic the top bearing its crushed from it. So no it would not be a good idea to reuse those in a hi performance motor.
The other set that Ted posted would be fine to put back in. I have scotchbrited and reused them when they come out looking like his. But the OP's are too far gone. So I still say he needs a set of new bearings and I would check the flatness of the crank and roundness of the rod before reassembly.

Then check your timing mark to make sure it's correct so you can keep the timing correct.