Quote:
You are thinking the wiring on the ballast is reversed? I am just learning this but I thought the ballast could be connected either side with the connections? What exactly is reversed the connections on the coil itself.
since i don't know the ohm readings on the ballast you have installed i am going by supplied information on what your ballast 'might' be. one side is 1.2 ohm and the other is .5 ohms. the 1.2 side should be routed to your coil and the .5 side to the box. also, above your post, SomeCarGuy has a very good point. make sure your ecu has a good ground. although a bad ground would just cause the motor to not run. a flaky one would drive you nuts with a work/no-work situation.
Last edited by mikemee1331; 09/09/12 05:48 PM.
