Got the remaining under car bars done, The window net fabbing is done & the snout bar engine front & mid plates are done. Just need to finish the chute handle lever & tabs, & driveshaft loop for now. I'll get some new pics tonight.
Then the only fabbing left to do is the rear axle spring perches, wheelie bar brackets & lower anti-roll bar tabs on the axle. I think we probably need to wait until I have it at ride height with all of the weight from the inteior, electrical, fuel system & drivertrain in to establish the correct pinion angle & locatation of the tabs. Or shoud I be O.K. to finish this & just shim the pinion angle later if needed later?