Threads Created By shanker

Threads Created \| All Posts Threads Created By shanker
Title	Forum	Post Time
The VGG Giveaway Duster with the LS 318 engine	Stu Harmon General Forum	11/07/23 04:55 PM
Need advice on removing steering gear input shaft seal	Moparts Question and Answer	03/08/23 01:47 AM
help finding Steering Column Linkage Bushing	Moparts Question and Answer	09/06/22 01:29 PM
Understanding the Corn Cob Duster Engine Failure	Moparts Question and Answer	08/31/22 01:02 PM
Need Suggestions on attaching fuel screen to pickup tube	Moparts Question and Answer	04/25/22 07:19 PM
727 extreme leak fix	Moparts Question and Answer	09/17/21 06:46 PM
Need input on throttle cable bracket solution for 360	Moparts Question and Answer	09/13/21 11:58 PM
Saginaw PS Pump Questions	Moparts Question and Answer	09/09/21 02:32 PM
Can I plumb the vapor separator line (from Fuel filter) to..	Moparts Question and Answer	08/23/21 05:15 PM
Watched this 1984 Rampage go 207.9mph @ the Texas Mile	Sandy's Truck Shop	03/29/21 02:58 PM
Need Help ID'ing a 727 Transmission	Moparts Question and Answer	11/06/20 05:19 AM
I would like to tell someone at Mopar Performance that....	Stu Harmon General Forum	11/02/20 09:09 PM
Issues installing Melling HV Oil Pump in Big Block 440 Truck	Sandy's Truck Shop	10/13/20 01:19 AM
Intake Casting # off of a 1974 440 Truck questions	Moparts Question and Answer	10/01/20 05:16 PM
Ignition Switch for 74 Ramcharger Problems & Conclusions	Sandy's Truck Shop	09/24/20 01:15 AM
Help Identify wire on 74 RC Forward Light Harness	Sandy's Truck Shop	09/23/20 01:27 AM
Ignition Wiring Problem I can't seem to figure out	Moparts Question and Answer	09/11/20 03:39 AM
How to identify how much to shorten driveshaft?	Sandy's Truck Shop	06/24/19 11:22 PM
Help with rear lift springs for a 74 Ramcharger	Sandy's Truck Shop	12/10/18 01:34 AM
Trying to figure out which springs for a 2" Lift on a 74 RC	Sandy's Truck Shop	10/15/18 06:48 PM

Page 1 of 3