|
Re: Grinding or sanding #3 bearing sides?
[Re: maximus]
#2207675
12/04/16 05:29 PM
12/04/16 05:29 PM
|
Joined: Jun 2003
Posts: 52,972 Romeo MI
MR_P_BODY
Master
|
Master
Joined: Jun 2003
Posts: 52,972
Romeo MI
|
Did you smack the crank back and forth with a dead blow hammer to set the bearings before you torque the caps
|
|
|
Re: Grinding or sanding #3 bearing sides?
[Re: maximus]
#2208249
12/05/16 06:27 PM
12/05/16 06:27 PM
|
Joined: Feb 2007
Posts: 5,080 organ
maximum entropy
master
|
master
Joined: Feb 2007
Posts: 5,080
organ
|
i'm with mr. p-body on this. i bet the bearing needs to be seated. i have NEVER had to increase thrust bearing clearance... that i remember.
for what is the good life if not doing things thoughtfully?
|
|
|
Re: Grinding or sanding #3 bearing sides?
[Re: maximus]
#2208255
12/05/16 06:34 PM
12/05/16 06:34 PM
|
Joined: Jan 2003
Posts: 19,363 Las Vegas
Al_Alguire
I Live Here
|
I Live Here
Joined: Jan 2003
Posts: 19,363
Las Vegas
|
Kinda how its done most of the time...
"I am not ashamed to confess I am ignorant of what I do not know."
"It's never wrong to do the right thing"
|
|
|
Re: Grinding or sanding #3 bearing sides?
[Re: maximus]
#2208296
12/05/16 07:48 PM
12/05/16 07:48 PM
|
crabman173
Unregistered
|
crabman173
Unregistered
|
Build enough and sooner or later you have to do a set that way I make sure and use a super flat surface
|
|
|
Re: Grinding or sanding #3 bearing sides?
[Re: maximus]
#2208428
12/05/16 11:20 PM
12/05/16 11:20 PM
|
Joined: Oct 2007
Posts: 4,206 New York
polyspheric
master
|
master
Joined: Oct 2007
Posts: 4,206
New York
|
Broken plate glass mirror and fine lapping compound, make figure-8s.
Boffin Emeritus
|
|
|
Re: Grinding or sanding #3 bearing sides?
[Re: dthemi]
#2208570
12/06/16 03:09 AM
12/06/16 03:09 AM
|
Joined: Jan 2003
Posts: 5,762 Hot Rod Ridge
FastmOp
master
|
master
Joined: Jan 2003
Posts: 5,762
Hot Rod Ridge
|
Sand the front side, not the thrust side. This
|
|
|
|
|
|