|
Re: Fan clutch for 68 RR
[Re: Scatransit]
#1000723
05/29/11 02:26 PM
05/29/11 02:26 PM
|
Joined: Jan 2003
Posts: 5,449 So Cal
Sinitro
master
|
master
Joined: Jan 2003
Posts: 5,449
So Cal
|
Quote:
I tried the 2765, but the flange diameter was too small. It did not support the bolts properly. The 1705 non-thermal is what I went with, it's closer to o.e. height at 1 1/2" vs. 1 1/4" and the flange diameter is closer to o.e. - if not exact. Although the Hayden units have slots instead of holes, the 1705 still is a better fit IMO. You can look through their catalog online and see the specs for all of their clutches. It's also inexpensive, I think I paid about $30 IIRC.
http://www.haydenauto.com/upload/HaydenAuto/Documents/Cat_Hayden/2007-hayden-fan-clutch.pdf
Another alternative is to search for a TRW FC28. The FC28 was an Mopar OE replacement, short height 2.75", closed 4-bolt hub...
Just my $0.02..
|
|
|
Re: Fan clutch for 68 RR
[Re: Sinitro]
#1000724
05/29/11 07:59 PM
05/29/11 07:59 PM
|
Joined: Mar 2006
Posts: 426 Mid-Atlantic
Scatransit
mopar
|
mopar
Joined: Mar 2006
Posts: 426
Mid-Atlantic
|
I'm pretty sure the height should be 1.25" not 2.75" ?? I'm not 100%, but I believe the 070 clutch - or one similar dimensionally - was used with all 26" radiator applications (not sure about A/C cars) where a Hemi, A12 Pkg, 4-speed 440, or 383 Axle Package was installed. And the height measurement was 1.25"...Someone else may want to chime in on this?
[oo]======[oo]
|
|
|
Re: Fan clutch for 68 RR
[Re: Scatransit]
#1000725
05/29/11 10:15 PM
05/29/11 10:15 PM
|
Joined: Jan 2003
Posts: 5,449 So Cal
Sinitro
master
|
master
Joined: Jan 2003
Posts: 5,449
So Cal
|
Quote:
I'm pretty sure the height should be 1.25" not 2.75" ?? I'm not 100%, but I believe the 070 clutch - or one similar dimensionally - was used with all 26" radiator applications (not sure about A/C cars) where a Hemi, A12 Pkg, 4-speed 440, or 383 Axle Package was installed. And the height measurement was 1.25"...Someone else may want to chime in on this?
The 2.75" height spec includes the total assembly, set it on a flat surface and measure its total height including hub and clutch assembly.
Just my $0.02..
|
|
|
Re: Fan clutch for 68 RR
[Re: Sinitro]
#1000726
05/29/11 11:24 PM
05/29/11 11:24 PM
|
Joined: Mar 2006
Posts: 426 Mid-Atlantic
Scatransit
mopar
|
mopar
Joined: Mar 2006
Posts: 426
Mid-Atlantic
|
I did not realize you were using "overall height"... I thought you were using "fan height"... It makes more sense now.
[oo]======[oo]
|
|
|
|
|
|