Welding up advance slots in M.P dist...

Print Thread

Re: Welding up advance slots in M.P dist... [Re: Mills] #833371 10/19/10 09:23 PM 10/19/10 09:23 PM
Joined: Feb 2009 Posts: 1,274 Ontario.Canada C can.al pro stock
can.al pro stock C Joined: Feb 2009 Posts: 1,274 Ontario.Canada	...is there a gauge that measures .250? the tech section says that .250 slot should give 22 degrees mechanical on the Mallory units.....correct?

Entire Thread
Subject	Posted By	Posted
Welding up advance slots in M.P dist...	72demon416	10/19/10 04:42 AM
Re: Welding up advance slots in M.P dist...	Ari440	10/19/10 04:46 AM
Re: Welding up advance slots in M.P dist...	Von	10/19/10 04:50 AM
Re: Welding up advance slots in M.P dist...	72demon416	10/19/10 05:18 AM
Re: Welding up advance slots in M.P dist...	six-barrel	10/19/10 05:28 AM
Re: Welding up advance slots in M.P dist...	72demon416	10/19/10 06:02 AM
Re: Welding up advance slots in M.P dist...	ademon	10/19/10 06:49 AM
Re: Welding up advance slots in M.P dist...	72demon416	10/19/10 06:59 AM
Re: Welding up advance slots in M.P dist...	Moparmal	10/19/10 07:11 AM
Re: Welding up advance slots in M.P dist...	493_DART	10/19/10 10:03 AM
Re: Welding up advance slots in M.P dist...	Crizila	10/19/10 11:55 AM
Re: Welding up advance slots in M.P dist...	Mills	10/19/10 09:21 PM
Re: Welding up advance slots in M.P dist...	can.al	10/20/10 01:23 AM
Re: Welding up advance slots in M.P dist...	493_DART	10/19/10 09:22 PM
Re: Welding up advance slots in M.P dist...	Crizila	10/19/10 10:50 PM
Re: Welding up advance slots in M.P dist...	Crizila	10/19/10 12:18 PM
Re: Welding up advance slots in M.P dist...	Von	10/19/10 01:40 PM
Re: Welding up advance slots in M.P dist...	72demon416	10/19/10 02:21 PM
Re: Welding up advance slots in M.P dist...	Dabee	10/19/10 04:26 PM
Re: Welding up advance slots in M.P dist...	CUDAJAS	10/19/10 04:44 PM
Re: Welding up advance slots in M.P dist...	Von	10/19/10 05:48 PM

Hop To