|
|
Re: EFI Fuel Pump - In Tank Installation
[Re: OzHemi]
#69883
06/10/08 09:49 PM
06/10/08 09:49 PM
|
Joined: Feb 2003
Posts: 4,204
Fort Worth, TX
Clair_Davis
master
|
master
Joined: Feb 2003
Posts: 4,204
Fort Worth, TX
|
Quote:
I have a tank from a 2004 Silverado too that I am not too attached too  it has the sending unit and all still as well. (is basically like new, was from a truck I parted out when it was near new) it is plastic as well..could chop it up in the name of science though...might have the same diameter sending unit assembly as the F body?  
Oz,
The plastic tanks are nice pieces, but only if you can use them as-is. They don't part out well because the plastic is REALLY thick, like over 1/4" in 2 layers of stuff. White on the inside, black on the outside. The lock ring setup for the pump is molded in to the plastic, and the plastic itself forms part of the sealing surface so you can't really cut/past parts. That's where the quest for the right o-ring begins...
Clair
|
|
|
|
|
|
|
